Usable Doors

You can access the usable doors via the button on the right side menu.

They are designed to print without any added supports. Instead, we have built supports right into the model!

After your print is finished, you will see a small hole on the top of the doorframe. Please stick a piece of 1.75mm wide filament into this hole and push it all the way through the door. You can then cut the filament flush with the top of the door frame.

Now apply pressure to the door blade. If it doesn't break free easily, use an X-Acto knife to cut through the built-in supports around the door blade. The door should then swing about 90 degrees in both directions!